This thread is for anyone working on personal projects to share their progress, and hold themselves somewhat accountable to a group of peers.
Post your project, your progress from last week, and what you hope to accomplish this week.
If you want to be pinged with a reminder asking about your project, let me know, and I'll harass you each week until you cancel the service.
Well, it seems this thread is still not doing too badly relative to the other regular threads, so let's stay on a weekly pace.
Jump in the discussion.
No email address required.
Notes -
Really cheap snap backs can be especially annoying to pull, but usually the concern in those cases is about scratches or cutting/stabbing yourself. The backs are really not supposed to take that much force to pop off to start with; if it could be bent with just a jeweler's screwdriver that sounds more like a manufacturing problem.
You can get specialty tools for it ("bench knife" or "watch case knife" for the traditionalists, but I don't recommend them; pry tools are safer and even vice-style ones exist if you're worried), but I've usually been able to work fine with normal electronics repair kit screwdrivers.
You want as wide of a flathead tip as you can get, while still fitting under the notch (or pry tool, or whatever). If it's really tight, using a plastic spadger or guitar pick around the edges while prying up from the notch can help a lot, but you don't want to try to dig anywhere closer to the center of the watch than that notch, and trying to slide metal around the edge will scratch stuff to hell.
There are special presses for pressing back on snapbacks (or you can even use button presses), but I've never found them particularly useful myself. Grab a hardcover book or softwood lumber, put the watch face-down on a clean and slip-resistant surface such as a mousepad. Start by pressing evenly from the top, and then give a little side to side pressure. It doesn't take that rigid of a shape and shouldn't take much force; I've seen people do it with a plastic level before.
Square notches along the back would point toward a twist-off threaded back, so the HF case opener tool should be the right one. There are different sizes and shapes of notch for threaded watch backs (and different configurations for even- versus odd- numbered notches), but that HF standard tool comes with a pretty wide variety that covers basically everything I've seen. Like above, these are better used with the face of the watch being pressed down into a clean slip-resistant surface, or you can get (or make with a few wood pieces) jigs to hold them in place so the watch doesn't spin while you're trying to unscrew the backplate. There are other variants of the tool if you know the notch type and count (and some weirder things like stress-ball tools that work great for cross-threaded backs), but most of them are worse to use in practice, so I don't really recommend.
Awesome! Thanks so much!
More options
Context Copy link
More options
Context Copy link