site banner

Tinker Tuesday for January 14, 2025

This thread is for anyone working on personal projects to share their progress, and hold themselves somewhat accountable to a group of peers.

Post your project, your progress from last week, and what you hope to accomplish this week.

If you want to be pinged with a reminder asking about your project, let me know, and I'll harass you each week until you cancel the service

Jump in the discussion.

No email address required.

I have a MiSTer FPGA with the Jammix card and a JAMMA (Japan Amusement Machine and Marketing Association) harness. So, in theory at least, it should be mostly plug and play. But there's a rats nest of wires so it's a bit intimidating.

It's a pretty standard two joystick and six buttons per side setup so there shouldn't be that much hardship. I do have to add a couple of wires myself since I'm going to wire it up using CHAMMA. (CHinese vs. Japanese -- The Chinese one support six buttons without an added harness)

The whole build was an adventure. I designed the basic outline of the cabinet and cut that. Basically everything else has been a matter of cut-to-fit after that. It's probably not the best way to do it, but it's fun and it's been a learning experience.

It's probably not the best way to do it, but it's fun and it's been a learning experience.

Story of my life. Sounds fun!

I think much of this is an effort to get out of a loop of analysis paralysis. I have a bad habit of overthinking things and not doing the things. A lot of this was (after getting frustrated of not doing things) just forcing myself to just take the next step. The worst likely outcome that may happen is I waste a pile of wood and time and trade that for experience.